No, it can only be programmed by our HaiwellHappy software.
H02RS module integrates with two communication ports, while H01RS module only has one communication port, all of Haiwell PLC are expandable to 5 communication ports except E series. Communication exte
1. After H32DT module is power-on, if the channel does not connect with any sensor, the indicator will be off. Connect to the sensor in sequence. Read the temperature value and write them to register
H04DT without RS485 interface can only be hung behind the host PLC for using; H32DT with RS485 interface not only can be hung behind the host PLC as the extend module, but also can be used as a remote
Haiwell firstly implemented the firmware upgrading function in the small programmable controller,whether it is the host CPU or extension module ,all could be upgraded freely,therefore the old products
The A+B- terminal of S04XA is a RS485 communication port. When S04XA is hung behind the host PLC as an extend module, the two terminals do not need any wiring; When the S04XA is used as a remote modul
Only these 3 types of expansion module don’t support DIP dial switch: 16-points digital module, 4-pointsanalog module and temperature module. The dial switch on expansion module can be used for
If the actual communication distance is greater than the allowed communication distance of RS485, you can add a relay to extend the RS485 communication distance.
